Reflow profile on MHP50 firmware 1.01

link

Hello,
I have an issue with refow profile on MHP50 firmware 1.01


In the "C" section the reflow (WeldTemp) temperature cannot be set to less than 230C. My application requires it to be 190C at maximum (or even less). Is there anthing that can be done to set the reflow temperature below 230C?

minidso

We have identified this issue and will make a major update to MHP50 early next month, including changing the temperature settings for reflow soldering.

link

Please include the ability to adjust the WeldTime to less than 30 sec.