Firmware questions and suggestions

KaylaMarie

When are you going to release the source code for the software in the MDP-M01?  There are a few things I would like to fix.  

-> Rolling the "menu" wheel away from you should move the cursor up, or in the case of changing the voltage should move the cursor to the left.  Rolling the wheel towards you should move the cursor down or in the case of changing the voltage should move the cursor to the right.  

-> Rolling the "value" wheel away from you should increase the value, rolling it towards you should decrease it.

-> When you first power on the MDP-M01 the far left soft key is blank until you either press it or switch to another screen and back to the "wave" screen, then it shows "Modify" like it should.

-> There is no option to set the key volume on the MDP-M01.

And also a suggestion, you should make a multimeter module to go with this set, that would make it a pretty versatile tool.

Thanks!

minidso

Thank you for your suggestion.
We will open source code as soon as possible

KaylaMarie

I also saw that there are other planned modules (Digital Signal Generator, Electronic Load, Power Charger, Battery Pack), is there any rough estimate on when they might be available?

Also, what type of wireless do they use to communicate?  Is it possible to develop 3rd party modules that would work with the MDP-M01?

minidso

Other modules can communicate with the display module via 2.4G.
Display module can control 6 devices

KaylaMarie

When will other modules be released?

minidso

KaylaMarie 发表于 2019-8-11 21:58
When will other modules be released?

We are work on it. maybe later of this year.

KaylaMarie

Another feature request, please add support for fahrenheit temperature display.

Thanks!