|
|
发表于 2024-12-14 09:59:01
|
显示全部楼层
after updating the station firmware using the file TS1C_APP_Ctrl_User_H180_V160.hex
when disconnecting power and connecting again, it forgets the config and goes back to 0 in the temp step
changing the temperature using the rotating knope doesn't work when first starting the iron,
going into settings I find that the temp step setting is 0
changing it to 1 or any other value works
but disconnecting power and connecting again it goes back to 0
Where can the old firmware files be found until this is fixed? |
|
发表于 2023-6-28 09:53:05
