Help! M01 bricked by firmware update!

Tony556

Hi! I have a Ryzen PC and a Intel Dell LaptopOn both Windows and Linux on both, I was unable to do the firmware update. And on the P905, it bricked when copying over 1.21. I had to get the ADDR and BIN file from the post. That worked only on the Intel Dell laptop.I tried the hex on the M01 on the laptop, and now it will not start up. Can I please get some help with this?

minidso

calaidia 发表于 2020-1-12 06:13
Hey, I ran into the same issue today with a brand new MDP-M01, using the latest firmware 1.21. The f ...

Please try upgrade MDP-M01 with bin file.
http://minidso.com/forum.php?mod=viewthread&tid=3696

minidso

Can I see the RDY file after M01 upgrade? What is the version you upgraded?

MyFastKO4

I have the same issue with the hex files on my MDP-M01 file, and after the upgrade it comes up with a MDP_M0~1.ERR file. This is both in linux and windows and both available firmware versions (1.20 and 1.21). My device is totally inoperable.
Ive attempted to attached the .ERR file (in a zip) for troubleshooting.

calaidia

Hey, I ran into the same issue today with a brand new MDP-M01, using the latest firmware 1.21. The first time it aborted coping the hex file, complaining not enough space is available. Usually copying the file aborts halfway and disconnects the drive. Please help with this issue

calaidia

It's working again. Thank you so much

Kabron

minidso published on 2020-1-13 10:24
Please try upgrade MDP-M01 with bin file.
http://minidso.com/forum.php?mod=viewthread&tid=3696

The same issue for both units(P905 and M01). I got .rdy file after copying binary, but it stays in DFU mode.For

minidso

Kabron 发表于 2020-1-25 21:03
The same issue for both units(P905 and M01). I got .rdy file after copying binary, but it stays in  ...

Have a video of always in dfu mode? Please email to service@minidso.com . We will replay after chinese new year.