Hardware 2.82 FGPA configuration error

dida

Hi,

I bought a brand new DSO203: Hardware 2.82, SYS Ver 1.64, Serial No 792BD89A).
I tried to install Wildcat Version 5.1 => but uploading app1.hex via DFU results in app1.err.
So I uploaded FPGA_281.ADR, 281_FPGA.BIN and app1.hex (all Wildcat 5.1)=> uploading is perfectly done  => but restarting dso hangs in splash screen with error "FGPA configuration error"
After that I tried these configurations without success:
- WC5.1: http://www.seeedstudio.com/forum/download/file.php?id=2339
- WC4.4: http://www.seeedstudio.com/forum ... mp;start=400#p21988
- http://www.seeedstudio.com/wiki/ ... mware#Firmware_List
- WC 6.0

Do you have any hints to go back to the original firmware or to get a matching FPGA File for WC?

Thanks a lot for help
Dida

sagittarius

go back to the original firmware: upload FPGA_281.ADR, 281_FPGA.BIN again.
First put FPGA_281. ADR and then into the .SET, put 281 _fpga. BIN


DSO203: Hardware 2.82 support WC5.1

dida

Hi sagittarius

I did like you wrote (I think so), but didn't work.

Downloaded WC5.1 from here: http://forum.seeedstudio.com/dow ... 58e505d6323d0ca1550
unzipping
Uploaded Files FPGA_281.ADR, 281_FPGA.BIN, app1.hex to DFU in this order.
Looks like that:

dida

The dso stops on booting and the splash screen looks like this

sagittarius

dida 发表于 2016-5-11 00:17
The dso stops on booting and the splash screen looks like this

You can try on Windows 7.
To upgrade the FPGA program,  re-enter the DFU to upgrade the  WC APP.

dida

Uploading using Windows 10 works.
I installed Wildcat 6.0 and it works perfectly.
Thanks for advice.