What should be the clearance of the bit

Yuri · 发表于 2022-10-20 19:55:23

本帖最后由 Yuri 于 2022-10-20 20:11 编辑

Hello.

The screwdriver is new, only one charge. A backlash of about 15...20 degrees. It is very inconvenient to use - you need to press the button, turn the screwdriver by 20 degrees and only after that the rotation begins.
What should be the backlash?

Thanks.

minidso · 发表于 2022-10-21 09:19:43

Please try setting the sensitivity to "high"
If you still have problems, please email: service@morningtools.com

		自动登录	找回密码
密码			立即注册

[Troubleshooting] What should be the clearance of the bit

社区居民

忠实会员